API of Anyplace Control

Connection to remote PC using command line

You can connect to remote PC using "Computer ID Connection" or "Online Account Connection" mode via command line. Command line is not supported for IP-address.

To use connection via command line, Admin Module must already be started (previously), even if it is not used .

After that run in the command line (as administrator ) :

For connection via ID:

apc_Admin.exe /portscreen:10206383620:123450

where 10206383620 - is ID of remote PC,
and 123450 - the password

For connection via Online Account:

apc_Admin.exe /AccountName=test@mydomain.com /AccountPassword=123456 /RemoteHost=MY_HOME_PC /RemotePassword=7890987

In this example test@mydomain.com is account name, MY_HOME_PC is name of remote Host (displayed in the address book), 123456 is account password and 7890987 is access password for remote Host (optional parameter).

Note: Unlimited corporate version allows to specify additional command line parameters ( /GatewayServer, /GatewayPort, /AccountUser)

At the same time , you can open a lot of remote control sessions simultaneously via command line.
But if you unload primary instance of admin module , all sessions will be closed.

Fixed Password for "Computer ID Connection" mode:

You can set constant password for QuickSupport module. Also QuickSupport module can be installed as a service (starts automatically with Windows). But it is possible in the "Unlimited Corporate" package of Anyplace Control only. Dynamic password is stored in the file:
C: \ ProgramData \ Anyplace Control Portable \ apc-settings.ini

If you open this file, you can see the following
[APC_HOST]
EncryptedPasswordForID = 123450


where 123450 - is the password.
Password must contain 6 digits, with the last digit 0 (necessarily).

If you want, you can change this password to any constant value.